Rate limit of of Gi port of CISCO7600 router

Rate limit of of Gi port of CISCO7600 router- ! mls qos ! class-map match-all teleb match any ! policy-map telebpm class teleb police rate 26214000 bps conform-action transmit exceed-action drop ! interface GigabitEthernet5/2 ip address A.B.C.D 255.255.255.255 shutdown service-policy input telebpm !

Assign IP address and route in Linux…

To assign a IP address to an interface of a Linux Host – ifconfig eth1 A.B.C.D netmask 255.255.255.x up Add a static route for any destination – route add -net A.B.C.0 netmask 255.255.255.x gw A.B.C.X Add DNS server IP at /etc/resolve.conf- search btraccl.com nameserver E.F.G.G nameserver 4.2.2.2

Firewall traces in debug mode

There are many debug commands that you can run to troubleshoot problems on Juniper firewalls. The most common debugs used are: Debug flow basic – shows the flow of traffic through the firewall, allowing for troubleshooting route selection, policy selection, any address translation and whether the packet is recieved or dropped by the firewall. Debug…

Bits, Bytes and Bandwidth Reference Guide

Bits, Bytes and Bandwidth Reference Guide 2001.01.01 01:53 EST by Philip Quick Conversions… For a quick reference, ue our Bits/Bytes Conversion Calculator. For the few people that care to learn it right (or be confused to death), read on 😉 The Bits vs. Bytes Confusion Let’s start with some background information on prefixes, by mentioning…

Set logging buffer size of a cisco router.

Configure log buffer size at Cisco router: By default, the buffer size for log in cisco router is 4KB which is not sufficient for a big router. If we need to cgange the buffer size, please enter the following command- hostname#conf t hostname(config)#logging buffer 1048576 !this will change the buffer size to 1MB. hostname(config)#